Home » CCNA mcq questions with answer – Set 16

CCNA mcq questions with answer – Set 16

Important Instructions:

  • Total Number Of Questions : 10
  • Passing Marks : 7
  • Each Question Carry 1 Mark, No Negative Marking.
  • Do Not Refresh The Page.
  • This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
  • Best Of Luck…

Results

-

#1. Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?

#2. Which of the following commands sets a trunk port on a 2950 switch?

#3. Which of the following is an IEEE standard for frame tagging?

#4. You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be? (Choose the most likely answer.)

#5. According to the graphic, which three commands can be used to establish a link with the router’s Fast Ethernet interface using the IEEE version of frame tagging?

Select all that apply:

You May Also Like :   CCNA mcq questions with answer - Set 11

#6. These two switches are not sharing VLAN information. From the output below, what is the reason why these switches are not sharing VTP messages?

#7. Which of the following provide inter-switch VLAN communication? (Choose two.)

Select all that apply:

#8. To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?

Select all that apply:

#9. Which of the following are benefits of VLANs? (Choose three.)

Select all that apply:

You May Also Like :   CCNA mcq questions with answer - Set 14

#10. Which of the following modes are valid when a switch port is used as a VLAN trunk? (Choose three.)

Select all that apply:

CHECK ANSWER
Rate this post
Scroll to Top