Home » CCNA mcq questions with answer – Set 8

CCNA mcq questions with answer – Set 8

Important Instructions:

  • Total Number Of Questions : 10
  • Passing Marks : 7
  • Each Question Carry 1 Mark, No Negative Marking.
  • Do Not Refresh The Page.
  • This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
  • Best Of Luck…

Results

-

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

2/5 - (1 vote)
You May Also Like :   CCNA mcq questions with answer - Set 6

Unfortunately…
You Did Not Pass. Why Not Try It Again?

2/5 - (1 vote)
You May Also Like :   CCNA mcq questions with answer - Set 18
Share your score!
Tweet your score!
Share to other

#1. What command do you type to save the configuration stored in RAM to NVRAM?

#2. Which of the following sequences will address this problem correctly?

#3. Which command will delete the contents of NVRAM on a router?

#4. What is the problem with an interface if you type show interface serial 0 and receive the above message?

#5. Which of the following can be used to establish a telnet session with a router?

#6. If you delete the contents of NVRAM and reboot the router, what mode will you be in?

#7. Which of the following can be used to configure a banner on your router that will warn someone who telnets into your router?

#8. If you want to display all the commands in the history buffer, which command will you use?

#9. Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface? (Choose three.)

#10. What layer of the OSI model would you assume the problem is in if you type show interface serial 1 and receive the above message?

CHECK ANSWER
2/5 - (1 vote)
You May Also Like :   CCNA mcq questions with answer - Set 14
Scroll to Top