Home » CCNA mcq questions with answer – Set 12

CCNA mcq questions with answer – Set 12

Important Instructions:

  • Total Number Of Questions : 10
  • Passing Marks : 7
  • Each Question Carry 1 Mark, No Negative Marking.
  • Do Not Refresh The Page.
  • This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
  • Best Of Luck…



#1. You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?

#2. For some reason, you cannot establish an adjacency relationship on a common Ethernet link between two routers. Looking at the output above, what is the cause of the problem?

#3. Which is true regarding EIGRP successor routes? (Choose two.)

Select all that apply:

#5. Which two of the following commands will place network into area 0?

Select all that apply:

#6. With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?

#7. What are three reasons for creating OSPF in a hierarchical design? (Choose three.)

Select all that apply:

#8. What is the administrative distance of OSPF?

#9. You have an internetwork as shown in the graphic above. However, the two networks are not sharing routing table route entries. Which command is needed to fix the problem?

#10. If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

Rate this post
Scroll to Top